DriSteem Vapor-Logic Guía de instalación descargar pdf (Pagina 7)

DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual • Page 5

S a f e t y p r e c a u t i o n s ( c o n t i n u e d )

• Installation must conform to the requirements of the authority having

jurisdiction or, in the absence of such requirements, must conform to:

In the United States: The National Fuel Gas Code, ANSI Z223.1

(latest edition).

In Canada: Local plumbing or waste water codes and other

applicable codes and with the current code CAN/CGA-B149.1,

“Installation Code for Natural Gas Burning Appliances and

Equipment,” or CAN/CGA-B149.2, “Installation Code for Propane

Burning Appliances and Equipment.”

In Europe: The National Gas Safety (Installation & Use) Regulations.

• Do not install in potentially explosive or flammable atmospheres

laden with grain dust, sawdust, or similar airborne materials.

• Installation of humidifier in high humidity or salt water atmospheres

causes accelerated corrosion, reducing the normal life-span of the

unit.

• To prevent premature heat exchanger failure, do not locate any gas-

fired unit in areas where chlorinated, halogenated, or acid vapors are

present in the atmosphere.

• Locate the humidifier in an area clear of combustible materials,

gasoline, and other flammable vapors and liquids.

• With the exception of sealed combustion units, do not locate units

in tightly sealed rooms or small compartments without provision for

adequate combustion air and venting. Room air combustion must be

supplied through a minimum of two permanent openings in the wall,

with at least one near the bottom. See the table and information on

Page 30 for additional information.

• Remove all shipping brackets and materials before operating the

humidifier.

• Do not locate humidifier in a negative pressure space. Combustion

products could be suctioned from the venting.

• Humidifier flue gases must be vented to the outside atmosphere.

• Power supply disconnect switch must be in the off position while

making wiring connections to prevent electrical shock and equipment

damage. All units must be wired in strict accordance with the wiring

diagrams furnished with this unit.

• Turn off all gas while installing the gas piping and manual shutoff

valve for the humidifier.

• The appliance and its individual shut-off valve must be disconnected

from the gas supply piping system during any pressure testing of that

system at test pressures exceeding 0.5 psig (3.5 kPa).

W A R N I N G !

Overview

1 2 3 4 5 6 7 8 9 10 11 12 ... 79 80

Comentarios a estos manuales

Sin comentarios

DriSteem Vapor-Logic Guía de instalación Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Deshumidificadores DriSteem Vapor-Logic