DriSteem Vapor-Logic Guía de instalación Pagina 58

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 57
Page 56 DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual
O p e r a t i o n : S t a r t - u p c o m m i s s i o n i n g
c h e c k l i s t
Visit date_____________________________________
Model #______________________________________
Serial #______________________________________
Tag #________________________________________
Supply water
DI
RO
Soft
Potable
Grains hardness ____________________________
Hot*
Cold
Water pressure ________________ psi
(must be between 25 and 80 psi
[172 and 582 kPa])
Water supply piping is 3/8" pipe thread (DN10) minimum
Float adjustments (DI system)
_________________________________________
Note: *If using heated supply water, disconnect the water sup-
ply line to the water tempering device at the fill manifold and
reconnect it to a cold water supply. This will ensure that the water
tempering device operates properly.
Gas supply
Natural
LP
Manifold pressure _____inches wc ( _____kPa)
Supply shutoff valve distance __________________
Supply line size _____________________________
Flue piping
Class _____________________________________
Size ______________________________________
Rise ______________________________________
Run ______________________________________
Slight pitch toward drip tee
Termination point capped and covered
Power venter location ________________________
Barometric damper location ___________________
Job site representation:
__________________________________________________
__________________________________________________
__________________________________________________
Job name___________________________________________
Program code _______________________________________
DRI-STEEM rep_______________________________________
Required clearances
Top cover removal 18" (457 mm)
Distance vent box to combustible 30" (762 mm)
Cleanout plate side 36" (914 mm)
Wiring
Control transmitter
Gauge _________
Shield
High limit duct humidistat
Gauge _________
Shield
Airflow proving switch
Power vent
Combustion air damper
Area-type fan
External fault contact
Twisted pair connection between boards
(for multiple units only)
Steam pipe
Outlet size _________________________________
Flange
Hard pipe
Insulated
Vapor hose (do not insulate)
Rise ______________________________________
Run _____________________________________
Pitched back to humidifier
45° angles used in piping
More checklist on next page ...
I m p o r t a n t : Troubleshooting information for this
humidifier is located in the Vapor-logic4 Installation and
Operation manual shipped with your humidifier. If you
do not have this manual, go to the literature section at
www.dristeem.com to download or order a copy.
Operation
Vista de pagina 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 79 80

Comentarios a estos manuales

Sin comentarios