DriSteem Vapor-Logic Guía de instalación descargar pdf (Pagina 15)

DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual • Page 13

Location

• The GTS outdoor enclosure must be level and located so there is

enough clearance for opening the access panels.

• Verify that the position of pad or curb properly supports the

unit and that support structure dimensions coincide with unit

dimensions.

• Do not locate unit in areas where the surrounding air has high

levels of particulates, such as some industrial parks or areas near

highways.

• Locate unit so air intakes are not too close to exhaust fan outlets,

gasoline storage, or other contaminants that potentially could

cause dangerous situations. Using and storing gasoline or other

flammable vapors and liquids in open containers in the vicinity of

this appliance is hazardous.

• When located on the roof, the air intakes must be a minimum of

14" (360 mm) off the roof to prevent intake of snow or splashed

rain. The unit should be located so prevailing winds do not blow

into the air intakes.

• An emergency drain is provided. In case of any water leak, water

drains onto the roof through this emergency drain.

• A keypad with standard 5' (1.5 m) cable ships mounted to

the subpanel in the GTS outdoor enclosure. The keypad must

not come in contact with the strip heaters or block the intake

ventilation hood.

• If constant monitoring of the unit is desired, or if the unit is

located in a severe climate, install a remote mount keypad.

Additional cable lengths up to 500' (152 m) are available as an

option for this mounting configuration.

• Curbs (optional) are shipped knocked down for ease of

transporting to the roof. Curbs are manufactured of 14-gauge

galvanized steel and shipped with all hardware for bolt-together

assembly. All holes are matched before leaving the factory. Curb

is to be a minimum of 14" (360 mm) high. A closed-cell curb

gasket with adhesive on one side is supplied with hardware. An

installation drawing also is included. To prevent moisture from

leaking into the building from either driving rain or melting

snow, install the gasket between the top of the curb and the base

surface of the unit.

O u t d o o r e n c l o s u r e m o u n t i n g

( c o n t i n u e d )

Installation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Sin comentarios

DriSteem Vapor-Logic Guía de instalación Pagina 15