DriSteem Vapor-Logic Guía de instalación descargar pdf (Pagina 52)

Page 50 • DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual

D i s p e r s i o n : R a p i d - s o r b ( c o n t i n u e d )

Steam supply connections to the Rapid-sorb header

1. Connect the steam supply interconnecting piping from the

humidifier to the Rapid-sorb. The steam supply piping requires

a minimum of 1/8"/ft (1%) pitch toward the header.

2. If multiple humidifiers are supplying one Rapid-sorb, a multiple

steam supply connector is provided.

• Typically, the multiple steam supply connector attaches to the

Rapid-sorb header supply end with hose cuff and clamps.

• Route the necessary number of steam supplies from the

humidifier tanks to the steam supply connector.

• Position the steam supply connector to accept the steam

supplies while maintaining the necessary pitch.

• Make sure the hose clamps on the steam supply connector

and header are tight.

Condensate drain connections to the Rapid-sorb header

1. Piping must be minimum ¾" I.D. (DN20) and rated for 212 °F

(100 °C) minimum continuous operating temperature.

2. Condensate drain line must be piped as shown in the figures

on the previous pages. Provide a 6" (152 mm) drop prior to a

5" (127 mm) water seal to:

• Ensure drainage of condensate from the header

• Keep steam from blowing out of the drain line

3. After the water seal, run the drain line to an open drain with a 1"

(25 mm) vertical air gap. Cut the drain line at a 45° angle on the

end above the drain to permit a direct stream of water into the

drain pipe while maintaining a 1" (25 mm) air gap. Locate air

gap only in spaces with adequate temperature and air movement

to absorb flash steam, or condensing on nearby surfaces may

occur.

4. All drain lines must be installed and sized according to

governing codes.

Installation

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 79 80

Sin comentarios

DriSteem Vapor-Logic Guía de instalación Pagina 52