DriSteem Vapor-logic3 Manual de instalación descargar pdf (Pagina 8)

Page 6 • DRI-STEEM Vapor-logic3 to Vapor-logic4 Adaptor Board Installation Manual

Indoor GTS

1. Remove GTS end panel (Figure 6-1) to access keypad/display

mounting screws.

2. Remove the four keypad/display mounting screws, and disconnect

cable from Vapor-logic3 keypad/display. Vapor-logic3 keypad/

display will not be re-used.

3. Plug cable into Vapor-logic4 keypad/display, position Vapor-logic4

keypad/display over opening, and tighten mounting screws.

4. Replace GTS end panel.

GTS with outdoor enclosure

Outdoor GTS humidifiers require the following hardware changes to

provide clearance for the ventilation fan:

1. Remove outdoor enclosure door that matches height of

replacement door shipped with upgrade kit. Screws will be re-used,

but not door.

2. Unplug power connection at fan, and remove fan and bracket

(Figure 7-1). Fan and bracket will not be re-used.

3. Unclip Vapor-logic3 keypad/display from bracket, unplug cable,

and remove bracket. Bracket and Vapor-logic3 keypad/display will

not be re-used.

4. Mount Vapor-logic4 keypad/display, fan, and bracket assembly on

subpanel. Use mounting screws provided and existing mounting

screw holes (see Figure 7-2).

5. Unclip Vapor-logic4 keypad/display from bracket, plug in cable,

and replace keypad/display on bracket.

6. Connect fan power using plug from Step 2, above.

7. Replace outdoor enclosure door with new door shipped with

upgrade kit. Re-use screws from Step 1.

Figure 6-1:

Keypad/display mounting screws

(indoor GTS)

Remove end

panel for access

to keypad/

display mounting

screws inside

of side panel.

OM-1222X

GTS humidifiers:

Keypad/display removal and

replacement

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Sin comentarios

DriSteem Vapor-logic3 Manual de instalación Pagina 8