DriSteem Vapor-logic3 Manual de instalación descargar pdf (Pagina 15)

DRI-STEEM Vapor-logic3 to Vapor-logic4 Adaptor Board Installation Manual • Page 13

Electric humidifiers:

Keypad/display removal and

replacement

The Vapor-logic3 keypad/display will not be re-used after this upgrade.

Vaporstream and CRUV with mounted keypad/display

1. Push keypad/display straight up to disengage its mounting keyhole

slots, and pull it off of mounting plate.

2. Disconnect cable from the Vapor-logic3 keypad/display.

3. Plug cable into new Vapor-logic4 keypad/display, and mount new

keypad/display.

4. Close and tightly secure control cabinet door.

Vaporstream and CRUV with unmounted keypad/display

1. Disconnect cable from Vapor-logic3 keypad/display.

2. Plug the cable into new Vapor-logic4 keypad/display.

Vapormist and Humidi-tech

1. On backside of subpanel keypad/display mounting location,

disconnect cable from Vapor-logic3 keypad/display.

2. Remove the four Phillips screws securing Vapor-logic3

keypad/display to sub-panel (save screws and re-use), and remove

keypad/display from subpanel.

3. Position new Vapor-logic4 keypad/display on subpanel, and plug

cable through subpanel and into back of keypad/display.

4. Secure keypad/display to subpanel using screws from Step 2.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

DriSteem Vapor-logic3 Manual de instalación Pagina 15