DriSteem Vapor-Logic Guía para resolver problemas descargar pdf (Pagina 37)

%3*45&&.7BQPSMPHJD*OTUBMMBUJPOBOE0QFSBUJPO.BOVBMt1BHF

4UFQo4FUVQ

Table 30-1:

Setup menu (continued)

Menu item Default value

Minimum

value

Maximum

value

Units Notes

Water management (continued)

Skim

(not an XT menu item)

-- -- -- --

Skim enabled Yes No Yes -- Enabled as default except on DI water systems.

Skim duration Model-specific 0 120 Seconds

End-of-season drain -- -- -- --

EOS enabled Yes No Yes --

Enabled as default except on DI water systems.

If enabled, the humidifier tank drains after the

humidifier has been idle for a user-defined time.

Idle time for EOS 72 1 168 Hours

Select number of hours humidifier is idle before end-

of-season draining starts.

Aquastat

(not an XT menu item)

-- -- -- --

The minimum aquastat setting prevents tank water

freezing. Higher settings keep tank water warm,

reducing time required to bring water to boiling after

a call for humidity.

Aquastat enabled -- No Yes --

Aquastat set point

50 40 180 °F

10 4 82 °C

Service interval -- -- -- --

Service interval

Model-specific 0 2,200,000 lbs

Select amount of water to be converted to steam or

hours that humidifier runs before service interval is

reached.

Model-specific 0 1,000,000 kg

Model-specific 0 10,000 Hours

Probe threshold -- -- -- --

Probe threshold 800 300 2000 --

Probe debounce time 2 1 10 Seconds

Amount of time the water probe must be in or out of

water to change the water/no water state.

Fill fault time 40 40 250 Minutes Amount of fill time before an alarm will occur.

XT management (XT only)

Tempering enabled Model-specific No Yes --

Enables drain tempering for XT. Tempering turns

on the fill valve whenever the drain is energized

and may not be required if the drain line can

accommodate boiling water.

TP Mode enabled Model-specific No Yes --

TP Mode allows the humidifier to more closely track

demand by cycling the contactor when current is

greater than the demand signal requirement.

Turn on percent 20 10 20 % Minimum run level when TP mode is disabled.

Fan-based dispersion

Changing fan-based dispersion settings can require

component changes for system to operate correctly.

SDU -- ------

An SDU is a space distribution unit, which disperses

steam using a fan housed in a cabinet.

SDU on system -- No Yes --

Area-type -- ------

An Area-type dispersion unit is a caged fan mounted

on top of the humidifier tank.

Area-type on system -- No Yes --

Time delay -- ------

Select number of minutes fan-based dispersion unit

operates after water in tank stops boiling. A delay

keeps the fan running until all steam is dispersed.

Output time delay 5 1 30 Minutes

Continued

Installation

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 103 104

Comentarios a estos manuales

Sin comentarios

DriSteem Vapor-Logic Guía para resolver problemas Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Deshumidificadores DriSteem Vapor-Logic