DriSteem Vapor-Logic Guía para resolver problemas descargar pdf (Pagina 20)

1BHFt%3*45&&.7BQPSMPHJD*OTUBMMBUJPOBOE0QFSBUJPO.BOVBM

4UFQo'JFMEXJSJOH

-JNJUDPOUSPMT

Airflow proving switch

Connect wiring for a duct, Space Distribution Unit (SDU) airflow

proving switch by inserting wires into the terminal block plug at

P13 (labeled AFsw and 24) per the wiring diagram on the next

page. Tighten screws; maximum torque is 3 in-lb (0.34 N-m).

(An SDU is a cabinet fan dispersion assembly.)

See also “Sensor placement” on Page 26.

Duct high limit switch or transmitter

Connect wiring for a duct high limit switch or transmitter by

inserting wires into the terminal block plug at P13 (labeled DHL

and 24) per the wiring diagram on the previous page. Tighten

screws; maximum torque is 3 in-lb (0.34 N-m).

Note: The duct high limit sensor connected at this location can

be an on-off high limit switch, or it can be a duct high limit

transmitter with an adjustable high limit set point (4-20 mA input).

See also “Sensor placement” on Page 26.

Terminal P13

Figure 16-1:

Terminal P13

Terminal P13:

24VDC = Power to duct high limit switch or transmitter

DHL = Duct high limit switch/transm. (4-20 mA input)

VAC = Power to airflow proving switch

AFsw = Airflow proving switch (24 VAC Input)

Installation

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Sin comentarios

DriSteem Vapor-Logic Guía para resolver problemas Pagina 20