DriSteem Vapor-Logic Guía para resolver problemas descargar pdf (Pagina 14)

1BHFt%3*45&&.7BQPSMPHJD*OTUBMMBUJPOBOE0QFSBUJPO.BOVBM

The Vapor-logic4 board is designed to make installation very easy:

t 5FSNJOBMCMPDLTUIBUSFRVJSFGJFMEDPOOFDUJPOTBSFPVUMJOFEJO

white.

t 5FSNJOBMQMVHTDBOCFSFNPWFEUPBMMPXFBTZBDDFTTXIFO

inserting wires and tightening screws.

t 'PSNPTUBQQMJDBUJPOTIVNJEJGJFSTTIJQXJUIUIFDPOUSPM

board fully configured, with drain, fill, and other humidifier

components factory-wired to the board, and the keypad/display

attached to the humidifier and connected to the Vapor-logic4

board.

Installing Vapor-logic4 is a three-step process:

1. Connect field wiring from device to Vapor-logic4 board.

See instructions beginning on Page 12. Note that some

connections listed here may not apply to your system.

t $POUSPMJOQVU (one required)

– RH or dew point transmitter

– Demand signal by others (4-20 mA or 0-10 VDC typical)

– Room or duct humidistat

– Demand signal by BACnet, Modbus, or LonTalk

t -JNJUDPOUSPMT

– Airflow switch (duct or SDU)

– Duct high limit on-off switch or transmitter

– Temperature compensation transmitter (or auxiliary

temperature sensor connected to same terminal)

*OTUBMMBUJPOQSPDFTT

Installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

Sin comentarios

DriSteem Vapor-Logic Guía para resolver problemas Pagina 14